2 Piece Seat Installation

Fitting Instructions: » View Printable PDF Version

Contents:
2 x plastic washers
2 x rubber washers
2 x small plastic washers
2 x metal nuts
2 x threaded rods
1 x nut tool

Please complete the following before placing on your toilet bowl.


1. Screw the Threaded Rod into Position B to start.

2. Loosen screw A slightly and lay the toilet seat onto the toilet pan.
Turn the round base plates equally on both sides into the approximate position so threaded rods will pass through the toilet pan holes.

3.If you are happy with the fit, remove the seat and tighten screw A.
Proceed with step 4. If awider adjustment is required, screw metal rod into position C and start again.

4.Place the two large plastic washers over the threaded rods, and place the seat onto the toilet pan, passing the threaded rods through the pan holes.
Check that the seat is aligned and slide the two black rubber washers, the 2 smallplastic washers and the metal nuts onto the threaded rods from underneath, tighten with the nut tool. Place the nut tool in a safe place
for future use.

Take a seat!!

If you need assistance, please email us.

» View Printable PDF Version